Command to start xscreensaver in arch4/18/2023 ![]() ![]() ![]() The first page is for editing the list of demos, and the second is. The main window consists of a menu bar and two tabbed pages. It is a tool for editing the /.xscreensaver file, and for demoing the various display modes. Now to start the xscreensaver daemon on login you need to search in Dash for startup applications. You can check if xscreensaver is running with the commands pgrep xscreensaver and ps -aux grep xscreens. The xscreensaver-settings program is a graphical front-end for setting the parameters used by the xscreensaver (1) daemon. Using this option also implies verbose output. xscreensaver-demo or search from the Dash: Click OK to both prompts asking to turn-off Gnome Daemon and to start xscreensaver-daemon respectively. To save the log to a file, you can set the path using the -log option. You can also add verbose: True to the /.xscreensaver file to make it persistent. This depends which value you have within your sktop file on line 4: Exec=xscreensaver -nosplash. To log verbose debugging information, start xscreensaver with the -verbose command line option. On my computer it's in /etc/xdg/autostart/sktop, then open it in an editor (terminal 'nano' may be best as you will need sudo commands to open it) and change 'Applicaton' to 'Application'.Īlso, different tutorials (such as liberiangeek and Radu's response) suggest using: "xscreensaver -nosplash"Īs the fix above uses. I start xscreensaver from i3's config file, but doing so from. Admittedly, I'm not so competent in that area. I've tried variations on the command, with /usr/bin, without, with -display, without, without -verbose. Since installed bumblebee, I supposed I can use Optimus with optirun command. I have the following in my /etc/lxdm/PostLogin: /usr/bin/xscreensaver -no-splash -verbose -log /var/log/xscreensaver.log -display :0.0 & It doesn't start xscreensaver. And the xscreensaver did not show the error message above anymore. if the touchpad was malfunctioning), but nothing registers here. 1 OS: Arch Linux (systemd) UI: LXDM logging in to Openbox. I've tried xev to see if events appeared without my input (e.g. This should, somewhere in the list, tell you where sktop is. Using xscreensaver-command -watch doesn't return anything interesting. To find out if this is the issue: first run locate sktop. Into your startup list, it would not work as xscreensaver is not set up with the type application. Therefore, if you have already entered the command "xscreensaver -no-splash" This causes the startup command to not work. 'Application' has been misspelt as 'Applicaton'. However, for some reason, in many of these tutorials, the above command is incorrect. They tell you to set up a sktop file with the following command: sudo gedit /etc/xdg/autostart/sktopĪnd then place inside it the following information: ![]() display host:display.screen The X display to use. As no answer has been marked as correct yet this could be this issue with running xscreensaver on startupĪs says here, many of the tutorials for setting up xscreensaver provide incorrect information. xscreensaver-settings accepts the following command line options. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |